I. Project introduction
The electrical part of the project was participated in the design, wiring, and debugging by our company. Using a variety of Delta products as well as the reject controller independently developed by our company, the automatic detection and control of pressure and slice weight deviations was effectively achieved, and the customer's Booking requirements.
The overall device is shown below:
The layout of the equipment in the power cabinet is as follows:
Separate type cabinet as shown below:
Second, the main system configuration
Third, the system requirements
1. Production requirements: 500,000 tablets per hour;
2. Tablet weight: The difference in tablet weight is controlled within ± 4%;
3. Waste control: The rejection accuracy is over 98%;
Fourth, interface introduction
Operation main interface:
The pressure value of each station is displayed, and the maximum and minimum pressures and the deviation from the set pressure are selected. With reference to this item, the upper and lower limits of reject can be set.
When the system is abnormal, an icon will be displayed in the upper right corner of each screen. Click this icon to enter the following screen. The abnormal item “normal†will become flashing. Click this button to inform the way of troubleshooting and troubleshooting. Press Reset to operate normally.
Fiber optic patch panel is now widely used in networks and it is an integrated unit for fiber management, we are offering various kinds of Fiber Optic Patch Panel, such as wall mounted fiber optic patch panel, rack mounted fiber optic patch panels. These equipment functions to fix and manage the fiber optic cables inside the box as well as provide protection.
Our wall mounted fiber patch panels accommodate up to 8 modular panels and is equipped with routing guides to limit bend radius and enhance strain-relief control. The 16-gauge steel with corrosion-resistant black powder finish coat housing provides excellent protection for the inside fibers. Wall-mount available unloaded, as well as having the capability to become a full-splice enclosure with mechanical terminations. A large variety of connector adapters are offered to meet your specific requirements. Such as SC, FC, ST, LC, etc, we can also pre-install various kinds of fiber optic pigtails inside the patch panel.
YLTelecom offers a series of changeable inside panels to fit for different kinds of the adaptor interface, and fit for both round and ribbon fiber optic cables. Our rack mounted fiber patch panels can be drawer type or economic type without draw design.
A Fiber-Optic Patch Panel is used to separate out the fibers within a fiber-optic cable. By using one of these panels, the fibers can be spliced to individual fibers on other cables, allowing the cables to be crossed and connected in a variety of ways. In addition, the panel creates a safe environment in which to work with exposed fibers.
There are two main types of Fiber-Optic Enclosures. One is a wall-mounted device, which, in its most basic form, can keep 12 different fibers separate from one another. If the fiber-optic cable has more than 12 fibers, the extra fibers can be moved to a second panel or an engineer can use a panel that is designed to hold more fibers separately. Wall-mounted panels can be constructed to hold up to 144 fibers at once.
The other type of Fiber-Optic Patch Panel is a Rack-Mounted Panel. This type of panel holds the fibers horizontally and is often designed to open like a drawer. Sliding the panel open gives an optical engineer easy access to the fibers inside.
Fiber Optic Patch Panel(ODF)
Fiber Patch Panel, Fiber Optic Patch Panel, Optical Patch Panel, Outdoor Fiber Optic Patch Panel, Optical Distribution Frame
NINGBO YULIANG TELECOM MUNICATIONS EQUIPMENT CO.,LTD. , https://www.yltelecom.com